In this guide, you will learn how to perform a hardware factory reset on an Aruba 505 Access Point. This method is useful when you do not have access to a console cable or the software interface.
Before starting, ensure you have a power source available for the Access Point (AP). This can be:
You will also need a small paperclip to press the recessed reset button.
Follow these steps to reset the device to its default factory settings.
First, ensure the device is currently unplugged from its power source. Locate the small reset hole on the back of the AP; it is typically located near the power adapter port.
Insert the paperclip into the reset hole and press down. You must keep holding this button down throughout the next step.
While continuing to hold the reset button with the paperclip, plug the power source (Ethernet cable or power adapter) back into the AP.
Continue holding the reset button for approximately 10 to 15 seconds.
Watch the LED indicators:
Once you see the final flashing behavior, you can release the paperclip. The Access Point will now boot up with factory default settings.